Metal Finishing Guide Book

2013

Issue link: https://metalfinishing.epubxp.com/i/218436

Contents of this Issue

Navigation

Page 312 of 843

305 Sulfuric or hydrochloric acid Sulfuric or hydrochloric acid 10% Fluoborate Acid nickel chloride 65% Sulfuric acid Alkaline cleaner Sodium cyanide Copper cyanide Copper Alloys Iron castings Lead Alloys Nickel Stainless steels Low steel carbons High steel carbons Zinc Cathodic strike Immersion Immersion and water rinse Immerse 10 to 15 sec 30 A/dm2; anodic for 2 min then cathodic for 6 min. Cathodic for 2 min Anodic at 6 V for 1 to 2 min Immerse or short anodic treatment Immersion Operation Conditioning Step Two Acid nickel chloride 10% Sulfuric acid Sulfuric acid plus sodium sulfate solution Cyanide copper Alkaline clean Coppy cyanide strike Solution Cathodic Cathoidc for 2 min at 16 A/dm2 Immerse for 5 to 15 sec Anodic at 10 to 40 A/dm2 At 6.5 to 10 A/dm2 Deposit copper at 2.5 A/dm2 for 2 min; then at 1.3 A/dm2 for 6 min Operation Table VII. Summary of Conditioning Steps in the Preparation of Metals for Plating This table only gives the final conditioning steps. These steps are preceded by other critical steps. For complete details see the section on Chemical Surface Preparation in this Guidebook and the Annual Book of ASTM Standards, volume 02.05 published by American Society for Test and Materials, Philadelphia. Details are given in other handbooks including Inco Guide to Nickel Plating, available on request from Inco,Saddle Brook, NJ 07662. Rinsing steps have not been included; in general, rinsing or double rinsing is beneficial after each conditioning step. Zincate or stannate Aluminum alloys Conditioning Step One Solution Basis Metal

Articles in this issue

view archives of Metal Finishing Guide Book - 2013