Metal Finishing Guide Book


Issue link:

Contents of this Issue


Page 500 of 843

Anodizing solutions: Cu, Zn, Mn Brass solutions: Pb, Cd, Cu, Ni, Zn Bronze solutions: Pb, Zn, Al, Cu, Ni Cadmium solutions: Cu, Pb, Zn, Ni Chromium solutions: Cu, Ni, Zn, Cl, SO4 Acid copper solutions: Cu, Cl Alkaline copper solutions: Zn, Fe, Pb, Cu Gold solutions: Au, Cu, Ni, Zn, In, Co, Cd Iron solutions: Mn Lead and tin-lead solutions: Cu, Cd, Ni, Zn, Sb Nickel solutions: Cu, Pb, Zn, Cd, Na, Co, Cr, Mn Palladium solutions: Pd, Cr3+, Cr6+ Rhodium solutions: Rh Silver solutions: Sb, Cu, Cd Acid tin solutions: Sn4+, Cu, Ni, Zn Alkaline tin solutions: Pb, Cd, Zn, Cu Acid zinc solutions: Cu, Fe, Pb, Cd Alkaline zinc solutions: Pb, Cd, Cu Wastewater: Cd, Cu, Cr3+, Ni, Sn, Zn AMPEROMETRY Amperometric titrations involve the use of polarography as the basis of an electrometric titration. Voltage applied across the indicator electrode (e.g., DME or platinum) and reference electrode (e.g., calomel or mercury) is held constant and the current passing through the cell is measured as a function of titrant volume added. The endpoint of the titration is determined from the intersection of the two straight lines in a plot of current against volume of titrant added. Polarograms are run to determine the optimum titration voltage. Amperometric titrations can be carried out at low analyte concentrations at which volumetric or potentiometric methods cannot yield accurate results. They are temperature independent and more accurate than polarographic methods. Although amperometry is useful for oxidation-reduction or precipitation reactions, few acid-base reactions are determined by this method. Some of the reactions that can be analyzed by amperometric methods are given in Table II. ELECTROGRAVIMETRY In electrogravimetry, the substance to be determined is separated at a fixed potential on a preweighed inert cathode, which is then washed, dried, and weighed. Requirements for an accurate electrogravimetric analysis include good agitation, smooth adherent deposits, and proper pH, temperature, and current density. Advantages of electrogravimetry include its ability to remove quantitatively most common metals from solution. The method does not require constant supervision. Disadvantages include long electrolysis times. Some of the metals that have been determined electrogravimetrically are cadmium, cobalt, copper, gold, iron, lead, nickel, rhodium, silver, tin, and zinc. SAMPLING Analyses are accurate only when the sample is truly representative of the solution being analyzed. Each tank should have a reference mark indicating the correct level for the solution, and the bath should always be at this level when the sample is taken. Solutions should be stirred before sampling. If there is sludge in the tank, 491

Articles in this issue

view archives of Metal Finishing Guide Book - 2013