Metal Finishing Guide Book

2013

Issue link: https://metalfinishing.epubxp.com/i/218436

Contents of this Issue

Navigation

Page 623 of 843

Fig. 10. Electrolytic metal recovery schematic. Ion Exchange Ion exchange is a chemically driven separation process. It is an ideal and useful separation method for collecting low concentrations of ionic materials, such as metal salts, from dilute rinsewater. This characteristic differentiates it from all of the previously discussed methods where relatively low flow rates and high concentrations of recoverable materials must be maintained. From a recovery standpoint, ion exchange is not capable of producing a "highly" concentrated stream for recycle (20-25 g/L is a practical limit). It is also difficult to optimize the split between recovered metal salts and excess regenerant acid, which is intolerable in the plating bath. Also noteworthy is the fact that a waste stream containing excess regenerant must be dealt with, as shown in Figure 8. NONRECOVERY METHODS Nonrecovery or indirect recovery methods do not return concentrate to the originating process; thus, they obviate any concern over accumulation of impurities or the primary metal in the bath. The result is a "decoupling" of the recovery process from the basic manufacturing operation, which may be a considerable benefit if downtime or process upsets cannot be tolerated. A general schematic is given in Figure 9. In certain instances, these nonreturn processes may also allow recovery from process bath losses other than drag-out (i.e., purification losses or plating bath desludging waste). This is in sharp contrast to the previous category of recovery methods, which can actually increase losses to purification or sludge removal 612

Articles in this issue

view archives of Metal Finishing Guide Book - 2013