Metal Finishing Guide Book

2011-2012 Surface Finishing Guidebook

Issue link: https://metalfinishing.epubxp.com/i/49721

Contents of this Issue

Navigation

Page 131 of 707

Table XX. Wood's Nickel Strike Bath Composition Component Nickel chloride Hydrochloric acid, 22[deg]Be Nickel anodes 110-125° F (43-52° Concentration 30-34 oz/gal (225-255 g/L) 10-12% v/v Sulfur free C). pH of first bath at 10-10.5. pH of second bath at 11.5-12.0. A proprietary grain refiner and anode corroder may also be added. Electrolytic Nickel The purpose is the same as the copper strike, protect and seal the zincate film, preparing the part for reception of additional deposits. (See Table XIX.) The bath is operated at the same current density as Watts nickel barrel and rack plating solutions. Time is just sufficient to cover the zincate. Bath pH should be maintained at 4.4 to 4.6 to minimize attack of solution on the zincate. Proprietary wetting agent and zinc tolerant Class I brightener (carrier) are normally added. Routine low current density (LCD) dummying at 5 to 10 A/ft2 is recommended to plate out zinc contaminant. Where possible, live entry into any of the described strike baths is recom- mended. This can be accomplished by using an auxiliary cable, while parts are in transit "live" to the strike bath. Plating begins as soon as the parts contact the solu- tion, significantly minimizing attack on the zincate. Alkaline Electroless Nickel The benefit of this bath is total, even nickel thickness of all exposed surfaces since this is an immersion process. The zincate itself is catalytic toward the electroless nickel solution. For a 10-min immersion the deposit thickness may range from 20 to 30 millionths of an inch, at 110° F (43° Low Carbon Steels (e.g., stampings and extrusions) Standard soak clean, electroclean, and acid dip, as described in process bath descriptions. High Carbon Steels (e.g., springs, fasteners, lock parts) Classified as above 0.35% carbon. Base metal has higher smutting tendency. Preferred acid dip consists of 25 to 40% v/v hydrochloric acid with additions of a pickle aid and wetting agent. The pickle aid minimizes attack on the base metal, greatly reducing tendency for hydrogen embrittlement. Stress due to hydrogen embrittlement can be relieved by baking at 350 to 400° F (177-204° C) for to 3 hours. Cast Iron Standard alkaline soak clean, followed by alternate hot and cold rinsing to push solutions out of pores. Anodically electroclean in alkaline descaler. Parts exiting the electrocleaner should have a uniform light yellow cast. Dip in 15 to 20% v/v Table XXI. Wood's Nickel Strike Operating Parameters Operating Parameter Temperature Anodic Treatment Cathodic Treatment 130 Range 75-90° 10-20 A/ft2 F (24-32° C) , 1-2 min (optional) 40-120 A/ft2, 2-3 min C). Bath pH is 8.5 to 10.0.

Articles in this issue

view archives of Metal Finishing Guide Book - 2011-2012 Surface Finishing Guidebook