Metal Finishing Guide Book

2012-2013

Issue link: https://metalfinishing.epubxp.com/i/98750

Contents of this Issue

Navigation

Page 219 of 903

Fig. 9. ���C��� spray pattern caused by dried material clogging the side port (A). To correct the problem, dissolve the dired material w ith thinner. Do not use metal devices to probe into the air nozzle opening. ey can buy, but without skilled operators the entire system will fail. Examine the following variables that can lead to problems in the finishing room. Failure to observe these rules may result in finishing problems. These are the five operator variables that must be controlled to improve application efficiency. 1. Distance of gun to work. 2. Stroking speed. 3. Pattern overlap. 4. Spray gun attitude (heeling, toeing, fanning). 5. Triggering. Figures 5 through 8 illustrate proper versus improper spraying technique. SPRAY PATTERNS AND PRESSURES The general rule of thumb for setting pressures is to always use the lowest pressure that will give a satisfactory pattern. This rule applies to all spraying processes. Failure to observe this rule, or using faulty or dirty nozzles, will usually result in faulty spray patterns. Typical patterns with suggested corrections are shown in Figures 9���13. Keeping the spray gun too far from the substrate will increase the likelihood of fallout. Fan patterns that are excessive in width will increase overspray. Excessive pressures will contribute to off-spray and rebound (see Fig.14). MAINTENANCE The spray gun is a precision tool and will perform best if kept clean and lubricated. Siphon Spraying: Wipe off the siphon tube with a solvent rag. Dip the siphon tube into a container of clean solvent and spray. Trigger repeatedly to thoroughly flush the passageway and clean the fluid nozzle and needle. (Consult local codes for restrictions on spraying solvent.) Gravity Spraying: Turn off atomization air to spray gun. Remove material from cup. Wipe interior of cup clean with solvent rag. Pour solvent into cup. Pull trigger allowing gravity to flush all fluid passages. Repeat until clean. Pressure Spraying: Substitute clean solvent under Fig. 10. Inverted tear-drop pressure for the paint being sprayed, using low fluspray pattern caused by dried material stuck to the outside id pressure (no atomizing air is necessary) trigger of the fluid nozzles tip (B), or the gun repeatedly to permit the solvent to flush out by a loose air nozzle or a bent the passageway. Do this until clean. fluid nozzle or needle tip. If dried material is the problem, Wipe off the gun body with a cloth wet with solremove air nozzle and wipe vent and lubricate the spray gun with a drop of light off fluid tip, using a rag wetted with thinner. Tightewn machine oil each day. the air nozzle and replace the needle, if bent. 214

Articles in this issue

view archives of Metal Finishing Guide Book - 2012-2013