Metal Finishing Guide Book

2012-2013

Issue link: https://metalfinishing.epubxp.com/i/98750

Contents of this Issue

Navigation

Page 284 of 903

strate was plated with 1.5 ��m nickel (followed by 0.3 ��m gold). The non-treated sample showed close to 100% complete wetting effect after activation. These same samples after post-dip treatment provided a contact angle of 76��. The results from all these tests highlight the strong hydrophobic properties of Betatec post-dip for both pure metal surfaces and electrodeposited nickel/gold. CORROSION RESISTANCE STUDY Reference standards were used to assist corrosion inspection and sample assessment.15 Typical laboratory corrosion test conditions utilize an artificial atmosphere provided by a climate chamber. The atmosphere can be carefully controlled with respect to humidity, temperature, and the desired concentration of corrosive gas or gas mixtures (e.g., sulphur dioxide, chlorine, nitric acid, etc.).16���18 Salt spray tests are also widely used, particularly the ���neutral salt spray test,��� which simulates the high salt content found in seawater or that used on highways during cold winter periods.19 In general, the choice Figure 5: Process sequence for the plating of of test was dictated by the application and copper-based samples. the expected corrosion severity. NITRIC ACID VAPOR (NAV) TEST The ASTM B-735 standard uses the ���nitric acid vapor test��� to evaluate porosity, and the extent of corrosion is microscopically measured by a quantitative pore count per surface area. Test requirements include: Figure 6: Corrosion inhibitor comparison (as corroded area after NAV testing) for Betatec and conventional products. ��� Temperature: 20���25��C ��� Air humidity of approximately 55% (never exceeding 60%) ��� Acid vapor provided from 70% w/w nitric acid reagent. The procedure involves placing nitric acid into a dry chamber or desiccator, followed by a delay period of approximately 30 minutes prior to introduction of the corrosion test samples. The ASTM standard specifies a duration of 60 min for gold thickness to 2 ��m. Required test time as a function of gold deposit thickness20: 60 �� 5 min for Au = 0.6���2.0 ��m 75 �� 5 min for Au = 2.0���2.5 ��m The actual duration used for this study was extended to 120 minutes to provide an increased severity of two times the ASTM standard. The gold thickness used throughout this study was fixed at 0.3 ��m (well 277

Articles in this issue

view archives of Metal Finishing Guide Book - 2012-2013