Metal Finishing Guide Book

2012-2013

Issue link: https://metalfinishing.epubxp.com/i/98750

Contents of this Issue

Navigation

Page 297 of 903

ACID COPPER BATH CONSTITUENTS The developed process was formulated for highvolume rigid PWB production. A sulfate-based copper plating system that is well established for PWB fabrication was utilized. The method presents low operational costs and is easy to conFigure 4: Tensile strength measured at 24��C and 35��C.. trol. The development work goal was to achieve a process that is temperature tolerant up to 40��C (104��F). The bath composition, as well as the plating parameters, are given in Table 1. HT 100 Make-up is a mixture of wetter/suppressor that aims to improve start-up and decrease dummy plating time for new baths. It is Figure 5: Elongation measured at 24��C and 35��C. used only for new makeups and after carbon treatments. HT 100 Brightener is responsible for copper grain refinement and internal stress reduction. It also has a leveling effect to smooth rough holes. HT 100 Wetter is a combination of organic additives that is used for replenishment during the plating process. TEST VEHICLES The test vehicle used in the process evaluation was 1.6-mm thick boards with various-sized through-holes. The through-hole diameters were 0.2, 0.25, 0.35, and 0.5 mm. The process flow included the following operations: Acid cleaner: Wets the hole and removes light soils. Rinse Micro-etch: Etch undercuts and remaining debris to ensure excellent copper-to-copper adhesion. Rinse Acid dip: Acidifies copper surface prior to plating. The plating was performed at current densities of 1.0, 1.5, 2.0, 2.5, and 3.0 ASD. The solution temperature was in the range of 22���40��F. PROCESS FEATURES Surface Appearance. Fine-grained deposits were obtained from this electrolyte. Plated copper was smooth and leveled inside the hole. No thin copper at the knee of the holes was observed. In addition, no plating folds or thin areas inside the through-hole were measured. Plating thickness was consistent throughout the 290

Articles in this issue

view archives of Metal Finishing Guide Book - 2012-2013