Metal Finishing Guide Book

2012-2013

Issue link: https://metalfinishing.epubxp.com/i/98750

Contents of this Issue

Navigation

Page 466 of 903

Table V. Sodium Borohydride-Reduced Electroless Nickel Bath Nickel chloride 31 g/L Sodium hydroxide 42 g/L Ethylenediamine, 98% 52 g/L Sodium borohydride Thallium nitrate pH Temperature 1.2 g/L 0.022 g/L >13 93-95��C (200-205��F) structural changes of the base substrate. Additionally, low temperatures are used (116OC/240OF) to relieve any hydrogen embrittlement that may be produced from pretreatment cycles or subsequent electroless nickel deposition. Postbaking of the deposit produces marked structural changes in hardness and in wear and abrasion resistance. Depending upon the temperature, bath composition, and phosphorus content, this postbake cycle will totally change the initial amorphous structure, resulting in nickel phosphide precipitation creating a very hard matrix. Complete precipitation of nickel phosphides does not occur at temperatures significantly below 399��C (750��F). In general, deposits with 9.0% phosphorus and above tend to produce lower as-deposited hardness values, but give slightly higher hardness when post-heat-treated. The coating will discolor above 250��C (482��F) in an air atmosphere. Prevention of coating discoloration can be accomplished in a vacuum, inert, or reducing atmosphere oven. Physical properties affected by the post-heat-treatment include increasing hardness, magnetism, adhesion, tensile strength, and electrical conductivity while decreasing ductility, electrical resistivity, and corrosion resistance. Thickness of the nickel-phosphorus deposit generally ranges from 2.5 to 250 ��m (0.1-10.0 mil). Deposits less than 2.5 ��m and greater than 625 ��m are currently and successfully being performed. The latter being typical of repair or salvage applications. Thickness measurements can be carried out with electromagnetic devices (eddy current), micrometers, coulometrics, beta backscatter, and X-ray fluorescence. Table IV gives an example of an acid hypophosphite-reduced bath. Alkaline nickel-boron solutions utilize the powerful reducing agent, sodium borohydride, to produce a deposit containing 5-6% boron and 94-95% nickel by weight. These highly alkaline solutions operate at a pH of 12.0-14.0 and temperatures of 90-95��C (195-205��F). These baths tend to be less stable because of their high alkalinity, and bath decomposition may occur if the pH falls below 12.0. Complexing agents such as ethylenediamine are used to prevent precipitation of nickel hydroxide. As-deposited hardness values of 650 to 750 VHN are typical. Table VI. Dimethylamine Borane-Reduced Electroless Nickel Bath Nickel sulfate 25 g/L Sodium acetate 15 g/L n-Dimethylamine borane (DMAB) Lead acetate pH Temperature 4 g/L 0.002 g/L 5.9 26��C (78��F) 459

Articles in this issue

view archives of Metal Finishing Guide Book - 2012-2013