Metal Finishing Guide Book


Issue link:

Contents of this Issue


Page 535 of 903

Figure 1: Jiggle cell panels (Images courtesy of Finishing Test Supply). There is a bottom, a face, a recess, and, finally, another face area. These images closely reproduce the types of contours and areas generally found on production parts in the plating tank. The bottom of the panel is useful for representing the lower portion of parts in the plating tank. Typical problems include pitting or air pattern haziness on the bottom of the panels. The two faces are good for representing the vertical areas of parts in the plating tanks. The recessed area mimics a typical recess on plating tank parts. It also represents the shelf or top of parts in a plating tank. JIGGLE CELLS Jiggle cells are usually supplied in various configurations: Air or mechanical agitation with heat and temperature control: This type of unit will allow the operator to check both air and mechanically agitated plating baths. The heating controls allow the operator to also check heatFigure 2: Air- and mechanically agitated jiggle cell. ed and unheated plating solutions. The motor on the right will move the cathode up and down, providing the mechanical agitation (Fig. 2). Air agitation with heat and temperature control: This unit will do air-agitated solutions but not mechanically agitated solutions. The unit does not have a motor to move the cathode panel up and down. See the example in Figure 3. JIGGLE CELL ANODES Jiggle cell anodes are usually 1 inch wide �� 7 inches or longer. The anode material will usually match the anode material used in the plating bath to be tested. The anode should be bagged to prevent anode fines or sludge from entering the solution. Figure 4 shows examples of various jiggle cell anodes. Test Procedure The test procedure should be standardized to allow for reproducibility between tests. All steps should be taken to ensure that the conditions in the jiggle cell closely match the conditions in the plating tank. Particular attention should be paid to the agitation, current density, and temperature. The finishing test equipment supplier will usually provide the user with recommended tips for the various plating tests. The cathode will need to be carefully prepared for each test with a standard526

Articles in this issue

view archives of Metal Finishing Guide Book - 2012-2013