Metal Finishing Guide Book

2012-2013

Issue link: https://metalfinishing.epubxp.com/i/98750

Contents of this Issue

Navigation

Page 705 of 903

require a minimum TE for certain coating operation in addition to a VOC or HAP content limit. If a catalytic or thermal oxidizer is used to control VOC or HAP emissions, 95% minimum destruction efficiency is generally required. An overall 90% minimum VOC or HAP destruction efficiency is generally required if a carbon or zeolite adsorber is used to concentrate emissions prior to destruction in an oxidizer. However, 80% combined system destruction efficiencies have been allowed for plastic parts spray booths employing a carbon adsorber in series with a thermal oxidizer. At least one permitting agency requires a minimum VOC control efficiency for major sources and others allow it as an alternative to laborious record keeping required to demonstrate compliance with individual coating emission limits. ��� Ohio Administrative Code (OAC) 3745-21-07 (G) Operations Using Liquid Organic Material requires discharge of organic materials (i.e. VOC) be reduced by at least 85% from applying, evaporating or drying any photochemically reactive material and any liquid organic material that is baked, heat-cured or heat polymerized. ��� Section 215.205 22 Illinois Regulation 11427 allows operators of coating lines alternative emission limitations to individual coating emission limits for emissions controlled by an afterburner (thermal oxidizer): 81% (75% for can coating) reduction in the overall emissions of volatile organic material from the coating line, and Oxidation to carbon dioxide and water of 90% of nonmethane volatile organic material (measured as total combustible carbon) which enters the afterburner. ��� Under South Coast Air Quality Management District (SCAQMD) of California (Los Angeles) Rules 1107 Coating of Metal Parts & Products and 1145 Plastic, Rubber and Glass Coating, lines may comply with these regulations using pollution control equipment provided VOC emissions are reduced as follows: ��� The control device shall reduce VOC emissions from an emission collection system by at least 95% by weight or the output of the air pollution control device is 50 PPM by volume calculated as carbon with no dilution. ��� The owner/operator demonstrates that the system collects at least 90% by weight of the emissions generated by the sources of the emissions. Other examples of minimum required or allowable VOC and HAP collection and destruction efficiencies can be found in various federal, state, and local regulations. In many cases the most advantageous type of oxidizer can be selected based on the following general guidelines. In other cases two or more oxidizer types may be practical and a detailed economic analysis based upon your specific costs of fuel and electricity will be required to determine the best selection. Recuperative Oxidizers A recuperative oxidizer is a direct-fired unit that employs integral primary heat 694

Articles in this issue

view archives of Metal Finishing Guide Book - 2012-2013