Metal Finishing Guide Book

2012-2013

Issue link: https://metalfinishing.epubxp.com/i/98750

Contents of this Issue

Navigation

Page 766 of 903

in place with the added support of a threaded top nut. This threaded top nut is needed to provide additional torque support for the top thumb screw when tightening the rack to the work bar. PCB cleaning can be done in a slotted basket. The basket should have 1/4-in. spacing between slots, be fabricated out of stainless steel, or be plastisol- or Halarcoated steel. Halar is a highly protective coating with high temperature characteristics, this coating is much more expensive than plastisol. In the case of very flexible contacts, it is necessary to design racks for each individual operation depending on parameters that are specific to each PCB operation. Some PCB racks have been designed with Fig. 6 Close up view of adjustable spine or cross members to accommodate difprinted circuit board (PCB) ferent size boards in each production process. tip showing only the stainless steel contact and PCB racks after a period of time will accumulate plastisol trimmed away for plating buildup in the contact area and will need to be a square fit for the PCB repaired to continue to be productive. The PCB racks are (two-point contact). repaired by stripping off the metal buildup and plastisol, repairing and cleaning the contact area for corrosion, and fixing the spine. The rack is then plastisol coated and trimmed to customer specifications. The contact area on a PCB rack is a slot with a contact point between the thumb screw and contact point. This slot is a specified width and the outside of the slot can be V-shaped to help with the racking of the board. Electroless Nickel Plating racks designed for electroless nickel can be as simple as using a strand of copper wire to hold the piece to be finished. Stainless steel contacts can also be utilized. Electropolishing Electropolishing racks can be grouped in the category of a rack that needs positive contact, usually a titanium tip, because of the need for chemical resistance. Copper spines are still used and the rack is plastisol coated. Racks should hold the work so that gas pockets will be eliminated. 753

Articles in this issue

view archives of Metal Finishing Guide Book - 2012-2013